







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
What a Chain Link Fence in Claremont, CA Actually Costs and How Long It Takes
A chain link fence in Claremont typically runs $3,500 to $9,000, and most residential jobs are finished in one to three days once permits and tree protection are sorted. The range covers everything from a short side-yard run off a Craftsman bungalow near the colleges to a full perimeter around a mid-century ranch lot with mature trees. Exact cost depends on linear footage, height, gauge, gate count, and what’s buried along the fence line. Call (844) 662-2335 for a free on-site measurement and a written line-item quote.
How We Build a Chain Link Fence, Step by Step

Chain link looks simple until you hit a root-bound property line in Claremont’s older neighborhoods. Here’s the real sequence, including what you’ll be deciding at each stage.
Stage 1: Site walk and layout (day 1, about 1 to 2 hours)
We walk the property line with you, mark posts every 8 to 10 feet, and flag anything the fence has to work around: sewer laterals, irrigation, tree roots, gas meters, and the property pins. This is where you decide the fence line itself. On lots with mature trees, that decision is bigger than it sounds, and we’ll get to why in the Claremont section below.
Stage 2: Permits and tree protection (day 1 to day 10, depending on scope)
Most chain link fences under 6 feet don’t require a building permit, but Claremont properties with protected trees or HOA oversight often need tree protection zones shown on a plan before anyone digs. We handle the paperwork and the coordination. If your fence is part of a full Fence Installation in Claremont project with gates, a driveway approach, or retaining work, that scope gets folded into the same submittal.
Stage 3: Demo and prep (day 2, half a day)
Old fence comes out, and we haul it. Post holes get dug to depth, and on Claremont’s clay-heavy soils we set posts in concrete rather than tamped gravel, because clay expands and contracts with the winter rains and a dry-set post will lean within two seasons. Hole depth runs 24 to 36 inches depending on height and wind exposure.
Stage 4: Posts, rails, and mesh (day 2 to day 3)
Terminal posts go in first and get braced. Then top rail, tension wire, and mesh, pulled tight with a stretcher bar rather than hand-pulled. Gates get their frames set and hung. A typical 150-foot residential run is a one-day install for our crew once concrete has cured enough to tension against.
Stage 5: Walkthrough and cleanup (day 3, about 30 minutes)
You walk it with us. Every gate gets opened and latched. We check tension, post plumb, and concrete finish, then clean the site. Any adjustment you want made happens before we leave, and the whole job sits under our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Chain Link Options You’ll Choose Between
Four decisions drive both the look and the number. Here’s the honest trade-off on each.
- Gauge (wire thickness): 11.5-gauge is the residential standard and holds up well; 9-gauge is heavier and better where kids, dogs, or balls hit the mesh, at roughly 20 to 30% more per linear foot. 12.5-gauge is lighter and cheaper and shows dents faster.
- Coating: Galvanized is the least expensive and fine in dry inland air. Vinyl-coated (usually black or green) costs more but looks cleaner against landscaping and resists the scuffing that galvanized shows over time. Black vinyl is the most common choice in Claremont’s older, more design-conscious neighborhoods.
- Height and top style: 4-foot reads as a boundary marker, 5-foot is the residential sweet spot, 6-foot gives real containment for dogs. A top rail plus tension wire is standard; a bottom tension wire adds cost but stops mesh from lifting at the ground.
- Gates: Walk gates run $150 to $400 installed depending on width and hardware. Drive gates cost considerably more and need heavier posts, deeper footings, and often a permit if they cross a driveway approach. Decide gate placement now, not after posts are set.
For properties where a fabricated structure is going up at the same time, homeowners often pair this with ADU Site Prep & Utilities in Claremont, since the fence line and the utility trench get coordinated once instead of twice.
What Chain Link Fence Costs in Claremont, CA

Plan on $3,500 to $9,000 for a residential chain link fence in Claremont. That’s a real range, not a placeholder, and here’s what pushes a job from one end to the other.
| Line item | Typical Claremont range |
|---|---|
| Chain link fence, installed (per linear foot) | $22 – $45 |
| Walk gate, installed | $150 – $400 |
| Removal and haul-away of old fence | $300 – $900 |
| Tree protection measures / arborist coordination | $200 – $800 |
| Rock or root excavation (per difficult post) | $75 – $250 |
What moves the number: linear footage is the biggest lever, since a 90-foot run and a 250-foot run are different jobs entirely. Second is existing condition, because an old fence tangled in roots and concrete footings takes longer to remove. Third is height and gauge. Fourth is gate count and hardware. Fifth is site access, since a narrow side yard where a wheelbarrow has to be carried in by hand adds labor.
What’s in a written quote: materials, posts set in concrete, tensioning, gate hardware, haul-away, and cleanup. What’s usually not: arborist fees if a protected tree needs evaluation, HOA review costs, and any survey work if property pins can’t be located. Our pricing is upfront and the number you see is the number you pay, with 0% financing for 18 months available and $1,000 off projects over $10,000.
See the difference
Before
After
Before
After
Before
AfterWhat Claremont Homes Specifically Do to This Job
Claremont is a City of Trees, and that changes chain link work here more than in any nearby city. The mature urban forest means a fence run often threads between root systems, and the city’s tree preservation ordinance can require a permit to remove or even prune a large tree, with construction plans showing tree protection zones before digging starts. We plan fence layout around root zones early, because discovering the conflict mid-dig is what delays a project. The mature canopy is also why galvanized mesh fails unevenly here: posts on the shaded side of a lot stay wet longer after winter rains and show surface rust years before the sunny side does, so we see mixed-condition fence lines that look half-new and half-finished.
The clay soils under many Claremont lots, particularly in the older blocks around the colleges and the ranch tracts off Indian Hill Boulevard, expand with moisture and shrink in the dry months, which is exactly why concrete-set posts matter. On the housing side, we’re working around Craftsman and Spanish Colonial Revival properties from the early 1900s where the fence line was set decades ago, plus mid-century ranches with fence runs that have shifted a few inches over the years. When an old gate opening no longer lines up, we handle the door and hardware side too, and homeowners often pair this with Door Installation in Claremont if a side entry is in the same project.
Serving Claremont, CA – Our Local Coverage Area
We serve Claremont and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Claremont

Most residential chain link fences take one to three days of install time, with permit and tree protection review adding a week or two up front if the property has protected trees. Call (844) 662-2335 and we’ll give you a real timeline after the site walk, not a guess.
Most residential chain link fences under 6 feet don’t need a building permit, but Claremont’s tree preservation rules can trigger review if the fence line crosses a protected tree’s root zone. We check the tree situation before we dig and handle any required submittal. Call (844) 662-2335 with your address and we’ll tell you what applies.
A residential chain link fence in Claremont typically runs $3,500 to $9,000 installed, with most of the spread coming from linear footage, gauge, gate count, and removal of an old fence. Call (844) 662-2335 for a written line-item estimate. It’s free and there’s no pressure.
No. Our pricing is upfront, and if the scope changes because of something we couldn’t see during the walkthrough, like a buried footing or an unmarked utility, we stop and talk to you before anything gets added. Call (844) 662-2335 to schedule your free estimate and get the number in writing.
Every chain link fence we install is covered by our 730-Day Done Right Promise, one of the longest workmanship guarantees in residential construction. If a post leans, a gate sags, or the mesh loses tension within that period, we come back and make it right. Call (844) 662-2335 to get started.
Get a Free Chain Link Fence Estimate in Claremont
We’ll come out, measure the run, walk the tree situation, and hand you a written line-item quote with no surprises. Live people answer the phones around the clock, so call whenever it’s convenient. Reach us at (844) 662-2335 to schedule your free estimate on a chain link fence in Claremont, and we’ll coordinate the rest across Claremont through our Fence Installation service.
Written by the team at Groundwork Construction Co.












