







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Glendora, CA: What the Job Actually Involves
Asphalt Driveways & Resurfacing in Glendora, CA typically runs $3,500 – $9,000 for new asphalt paving and $250 – $700 for a reseal coat, with most residential jobs finished in one to three days depending on size and base condition. The work covers excavation of the old surface, a compacted aggregate base, hot-mix asphalt laid at 2 to 3 inches, and edge grading so runoff moves away from the slab rather than pooling against it. Call (844) 662-2335 and we’ll walk your driveway, check the base, and put a written number in your hands.
How We Build or Resurface an Asphalt Driveway, Stage by Stage

An asphalt driveway is only as good as the base under it. Most of the failures we get called out to in Glendora trace back to a base that was never compacted properly or never drained, not to the asphalt itself. Here’s the order we work in.
Stage 1 – Walkthrough and base assessment (day 1, about an hour). We probe the existing base, check for soft spots and root intrusion, and measure slope and drainage direction. You decide at this point whether we’re resurfacing over a sound base or doing a full replacement. If the base is failing, a seal coat or overlay just buys you a season.
Stage 2 – Demolition and excavation (day 1 to day 2, four to eight hours). The old asphalt comes out, along with any failed base material. We cut clean edges, haul off debris, and grade the subgrade to the finished slope. On hillside lots above Sierra Madre Avenue, this is where we spend extra time: getting water to sheet away from the house instead of running down toward it.
Stage 3 – Base installation and compaction (day 2, roughly half a day). We lay a compacted aggregate base in lifts and run it with a plate or roller until it’s dense enough to carry the load. This is the step that gets skipped on cheap bids, and it’s the step that determines whether you’re calling someone again in four years or fourteen.
Stage 4 – Hot-mix asphalt paving (day 2 or day 3). Hot mix goes down at 2 to 3 inches for residential driveways, raked to grade, rolled while it’s still workable, and compacted to density. Edges get tamped and finished. You decide here on thickness and mix grade, which we’ll cover in the next section.
Stage 5 – Cure, stripe, and walkthrough (day 3 to day 30). The asphalt needs to cure before you park on it. We set the timeline with you, mark any striping, and do a final walkthrough so you can see the grade, edges, and drainage before we call it done. Full cure takes weeks; light foot traffic is fine much sooner.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Make Before We Break Ground
Asphalt isn’t one product. The spec decisions below are the ones that actually change how long your driveway holds up, and what it costs.
- Asphalt thickness (2″ vs. 3″). Two inches works for a light-use residential driveway. If you park a heavy truck, tow a trailer, or have a steep grade that takes more load, three inches is the honest answer. It adds to the cost, but it’s cheaper than repaving early.
- Base depth and material. Four to six inches of compacted Class II aggregate is standard for residential. Deeper base costs more but is the single best insurance against cracking. On expansive foothill soil, base depth matters more than anywhere.
- Resurface vs. full replacement. Resurfacing an overlay onto a sound base is faster and less expensive. If the base is failing, the overlay cracks from underneath within a couple of seasons and you’ve paid twice.
- Seal coat timing and type. A seal coat protects against UV and water intrusion. Fresh asphalt needs to cure before it’s sealed. Asphalt emulsion sealers are the standard; coal-tar sealants are being phased out in many markets and we generally steer away from them.
- Edge treatment and drainage. Asphalt edges need support or they crumble. You can choose a compacted shoulder, a concrete curb, or landscaping borders. On hillside lots this is where drainage decisions get made, and they matter as much as the paving.
We also work with prefab and modular partners like Cover and Dvele on accessory structures that sit alongside a driveway, where the pad and approach need to be coordinated with a prefab build schedule. If your driveway is part of a full Driveway & Pavers in Glendora scope, we’ll sequence it so the paving happens after the heavy deliveries are done.
Asphalt Driveways & Resurfacing Costs in Glendora, CA

Here’s what the numbers look like. These ranges are market-calibrated for Glendora, and we hold to them in a written estimate.
| Line Item | Typical Range |
|---|---|
| New asphalt paving, full install | $3,500 – $9,000 |
| Driveway replacement (demo + new) | $5,000 – $14,000 |
| Seal coat (single application) | $250 – $700 |
What pushes a job toward the high end?
- Square footage. A single-car approach is a different job than a long run up to a hillside garage.
- Existing base condition. Soft spots, root damage, and failed subgrade mean more excavation and more aggregate. That’s the biggest variable.
- Access and haul-off. Tight lots and steep grades slow the equipment and add haul costs.
- Thickness and base depth. Going from 2″ to 3″ plus deeper base is a real cost increase, and sometimes the right call.
- Drainage work. Adding a swale, catch basin, or curb is a separate line item and adds to the total.
A written estimate covers excavation, base, asphalt, compaction, edge finishing, and haul-off. It typically does not cover drainage structures, retaining work, or striping unless we’ve itemized them. Ask for the itemization. No-hassle upfront pricing means the number you see is the number you pay, and the work is covered by our 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat Glendora Homes Specifically Do to This Job
Glendora’s construction market splits in two, and both halves affect asphalt work. The flat core around downtown, ZIP 91740, is mid-century ranch homes and older bungalows from the 1920s through the 1960s. On those lots, we’re often tearing out original concrete or failing asphalt and rebuilding the base from scratch. The foothill side, ZIP 91741, holds 1970s through 1990s custom homes on sloped lots, and the grade changes everything: runoff from the San Gabriels, expansive native soil, and canyon drainage all push water toward the driveway. On those hillside streets, getting the slope, the edges, and the drainage right is what makes the job last. It’s also why the same driveway on a foothill lot can cost meaningfully more than one on flat ground in Covina or Azusa. The seasonal Santa Ana winds and dry summers aren’t the asphalt’s enemy so much as the winter rain is: a driveway that doesn’t shed water is a driveway that cracks. If your approach needs drainage, retaining, or fire-defensible exterior work coordinated, our Glendora team can scope that alongside the paving, and homeowners often pair this with Chain Link Fence in Glendora or, on lot splits and accessory builds, ADU Site Prep & Utilities in Glendora.
If you want the wider scope of hardscape and paving, our Driveway & Pavers service covers it, and any paving permit or inspection requirement on your lot gets pulled and passed before we call the job done.
Serving Glendora, CA – Our Local Coverage Area
We serve Glendora and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Asphalt Driveways & Resurfacing in Glendora

Most residential Asphalt Driveways & Resurfacing jobs in Glendora take one to three days on site, with new asphalt ready for light foot traffic within a day or two and vehicle traffic after curing. Larger hillside jobs with drainage work can run longer. Call (844) 662-2335 for a timeline based on your actual lot.
Some paving work requires a permit, especially when you’re changing grade, drainage, or the driveway’s footprint near the right-of-way. The rule depends on your lot and scope, and we’ll tell you honestly whether yours triggers one. Call (844) 662-2335 and we’ll confirm before the estimate.
Resurfacing works when the base is sound and the existing surface isn’t badly cracked or rutted. If the base has failed, an overlay will crack from underneath within a season or two. We probe the base during the walkthrough and give you a straight answer, not the more profitable one.
A seal coat in Glendora runs $250 – $700, while a full overlay or replacement runs $3,500 – $9,000 for paving and $5,000 – $14,000 for a full replacement with demo. The base condition and square footage drive the number. Call (844) 662-2335 for an exact quote, free of charge.
All of our Asphalt Driveways & Resurfacing work in Glendora is backed by the 730-Day Done Right Promise: if it isn’t done right, we make it right. That’s one of the longest workmanship guarantees in residential construction, and it’s in writing. Call (844) 662-2335 to schedule your free on-site estimate.
Get a Free Asphalt Driveway Estimate in Glendora
Call (844) 662-2335 to schedule a free on-site estimate for Asphalt Driveways & Resurfacing in Glendora. We’ll walk the driveway with you, probe the base, check drainage, and hand you a line-item written quote before you commit to anything. Calls are answered by a live person around the clock, and our technicians are background-checked and arrive in uniform. Financing at 0% for 18 months is available, plus $1,000 off projects over $10,000.
Written by the team at Groundwork Construction Co.












