







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in San Dimas, CA: What It Takes and What It Costs
Asphalt driveways & resurfacing in San Dimas, CA typically run $3,500 – $9,000 for a new asphalt driveway and $250 – $700 for a reseal and resurface coat, with most residential jobs finished in two to four days once grading is set. The work is a full-depth build: excavate the old surface, compact a base, grade for drainage, then lay hot-mix asphalt in lifts. Call (844) 662-2335 for a free on-site estimate.
How We Build an Asphalt Driveway, Stage by Stage

Every San Dimas job starts with a walk of the existing surface and a measurement of the slope. We look at where water leaves the driveway, how the apron meets the street, and whether the base underneath is still sound. From there, the sequence is fixed.
Stage 1 – Site walk and layout (day 1, about an hour). We measure the drive, check the street apron grade, and note any utilities or drainage structures in the path. You decide the width, the edge treatment, and whether you want a widened turnaround or a second parking pad. This is the moment to settle those choices, before anything gets dug.
Stage 2 – Demo and excavation (day 1, 3 – 6 hours). The old asphalt or concrete comes out and gets hauled off. We dig down to the subgrade, usually 6 to 10 inches depending on soil and traffic load. On the valley-floor lots around San Dimas, that subgrade is often sandy alluvial soil that drains well but shifts under load, so we compact in lifts rather than relying on the native soil holding shape.
Stage 3 – Base and grading (day 2, 4 – 6 hours). A crushed aggregate base goes down and gets compacted with a plate or roller, then graded to a minimum slope so water runs to the street or a drainage point instead of pooling against the garage slab. You decide at this stage whether a channel drain or a small swale is worth adding for a low corner.
Stage 4 – Asphalt placement (day 2, 2 – 4 hours). Hot-mix asphalt arrives and gets laid in one or two lifts, raked to grade, and rolled while it’s still workable. For a standard residential drive, we pour 2 to 3 inches of compacted asphalt over the base. The edges get tamped and shaped. This is the stage where temperature matters most, so we don’t lay asphalt on a cold morning or in the middle of a rain window.
Stage 5 – Cure and seal (day 3 to day 4, plus a cure window). The new surface cures for a few days before normal vehicle traffic. Full cure takes longer, and we schedule the first protective seal coat for a later visit, usually months out, once the asphalt has fully set. You get a written timeline for when to drive on it, when to park heavy vehicles, and when to schedule that first seal.
Total active construction for a typical San Dimas residential driveway is two to four working days. Resurfacing-only jobs, where the base is sound and we’re adding a fresh wearing course, can finish in a single day.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
- Full replacement vs. resurface overlay. Full replacement tears out to subgrade and rebuilds everything, which is the right call when the base is failing, cracking runs deep, or drainage is wrong. An overlay adds a new layer over a sound existing surface and costs far less, but it inherits whatever problems the base already has. We only recommend an overlay when we’ve confirmed the base is solid.
- Asphalt thickness. A standard residential drive takes 2 to 3 inches of compacted asphalt over a proper base. A heavier-duty drive meant for an RV, trailer, or regular truck traffic needs more base and a thicker wearing course. The trade-off is straightforward: more thickness means more cost and more durability under load.
- Base depth and material. A shallow base saves money and fails sooner. A deeper, well-compacted aggregate base costs more up front and is what keeps the surface from rutting and cracking through San Dimas’s hot summers.
- Edge treatment. Exposed aggregate edges, asphalt curbing, or a border of pavers along the sides. Pavers as an accent edge look sharp and hold up well, but they raise the price and add a step to the schedule.
- Seal coat timing and frequency. A fresh seal protects against UV and water intrusion. Too soon and it traps moisture in uncured asphalt; too late and the surface starts to oxidize. We give you a written schedule rather than a generic “every couple of years.”
- Drainage additions. A channel drain, a grated inlet, or a small swale at a low spot. Worth the extra cost when a corner of the drive puddles or when the drive sits below the garage slab.
See the difference
Before
After
Before
After
Before
AfterWhat Asphalt Driveways & Resurfacing Costs in San Dimas, CA

For San Dimas, plan on $3,500 – $9,000 for asphalt driveway paving, and $250 – $700 for a seal and resurface coat. A full driveway replacement across all surfaces runs $5,000 – $14,000. If you’d rather compare against other surface types, our Driveway & Pavers service covers concrete and paver builds that often land in a similar range.
Here’s what actually moves that number:
- Square footage and driveway length. A short two-car drive sits at the low end. A long drive climbing from the street or wrapping around a side yard pushes toward the top, since every extra square foot adds asphalt, base, and labor.
- Existing condition. A driveway that’s already failing, with a broken base or deep cracks, costs more to remove and rebuild than one that just needs a fresh surface.
- Base depth and soil. Deeper base and soil that needs correction add to the excavation and material line.
- Access. A driveway tucked behind a gate, down a narrow side yard, or with limited room for a dumpster and equipment adds handling time.
- Drainage and edge work. Adding a channel drain or paver border is a real line item, not a rounding error.
A written estimate from us lists the excavation, base material and depth, asphalt thickness, edge treatment, drainage, haul-off, and the final grade. It also spells out what isn’t included, like relocating a utility line or replacing a damaged street apron if the city requires it. No-hassle upfront pricing means the number you see is the number you pay.
What San Dimas Homes Specifically Do to This Job
San Dimas sits at the mouth of the San Gabriel Valley, where the alluvial fan meets the foothills below the San Gabriel Mountains, and that geography shapes asphalt work here in ways flat-valley neighbors don’t deal with. On the foothill streets above downtown, driveways climb, and a sloped drive holding hot-mix asphalt needs a compacted base that resists creep far more than a level valley-floor pad does. Winter rain on those slopes is where we see the most failures: water runs off the decomposed granite above and finds any weak seam in the asphalt, then works it open. That’s why driveway drainage and edge grading get more attention on a hillside San Dimas property than they would on a flat lot.
The housing stock across ZIP 91773 is a mix of mid-century and 1960s-80s single-family homes on the valley floor and steeper custom homes climbing into the foothills, many with original slabs and older driveways that have never been rebuilt. Hot, dry summers and Santa Ana wind events dry out and oxidize older asphalt fast, so a lot of the drives we see here are cracked and raveled rather than worn evenly. When a driveway rebuild is part of a bigger project, homeowners often work it through Driveway & Pavers in San Dimas and pair it with ADU Site Prep & Utilities in San Dimas, since both come down to grading and base work under the same slope conditions. We cover the whole of San Dimas, and homeowners here also often pair a new drive with Chain Link Fence in San Dimas to reset a property line at the same time.
Serving San Dimas, CA – Our Local Coverage Area
We serve San Dimas and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Asphalt Driveways & Resurfacing in San Dimas

Most San Dimas asphalt driveways take two to four working days of active construction, plus a cure window before normal traffic. A resurface-only job on a sound base can finish in a single day. Weather decides the exact schedule, especially in the winter rain months on the foothill slopes. Call (844) 662-2335 for a firm date on your property.
Many driveway projects that touch the street apron, curb, or a slope on or near a hillside lot need city review, and hillside properties can trigger grading review. We handle the permit process and inspections as part of the job. Call (844) 662-2335 and we’ll tell you what’s required for your address before you commit.
Yes, if the existing base is sound and the cracks don’t run deep. We check the base first, and if it’s solid, an overlay adds a new wearing course for far less than a full rebuild. If the base is failing, an overlay only buys you a few years, so we’ll tell you straight. Call (844) 662-2335 for an on-site call.
Expect $3,500 – $9,000 for asphalt paving and $250 – $700 for a seal and resurface coat, with full driveway replacement at $5,000 – $14,000. Length, base condition, access, and drainage additions move the number. Call (844) 662-2335 for an exact quote, with a written line-item estimate at no charge.
Every asphalt driveway we build is backed by our 730-Day Done Right Promise: if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in residential construction, and it’s in writing. Call (844) 662-2335 to ask what it covers for your project.
Written by the team at Groundwork Construction Co.












