







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
What a Paver Driveway Costs in San Dimas, CA, and How Long It Takes
Paver driveways in San Dimas typically run $7,000 to $18,000 and take about 4 to 6 working days from demo to final sweep. That covers excavation, a compacted base, edge restraint, the pavers themselves, and polymeric sand in the joints. A standard two-car apron on a flat valley-floor lot lands nearer the low end; a graded foothill approach with curves, drainage, and a drainage channel climbs toward the top. Call (844) 662-2335 to schedule a free on-site estimate. We’ll measure, walk the slope, and hand you a written line-item quote.
How the Job Actually Runs, Day by Day

Most homeowners want to know what the week looks like before they commit. Here’s the honest sequence we follow on paver driveways in San Dimas, with the decisions that fall on you at each step.
Stage 1: Layout and demo (day 1)
We mark the finished edges with string and paint so you can see the driveway’s footprint before anything comes out. Then the old surface comes up: concrete, asphalt, or the tired pavers that started this conversation. On a typical two-car drive, demo and haul-off take a single day. You approve the final footprint here, so walk it and speak up about that oak’s root zone or the walkway you’ve been meaning to join.
Stage 2: Excavation and base prep (days 1 to 2)
A paver drive is only as good as what’s under it. We excavate 8 to 12 inches, then build a compacted aggregate base in lifts, running a plate compactor over each one. On San Dimas foothill lots with fall, we may need more depth or a stabilizer on the subgrade. This is also where we check slope for water, and it’s the stage that quietly decides whether your driveway sheds rain or puddles at the garage door.
Stage 3: Edge restraint and bedding sand (day 2)
We set a rigid edge restraint along both sides, then screed a uniform bedding layer for the pavers to sit on. Skipping the restraint is the top reason driveways creep and spread years later. You don’t decide anything here, but this is the check you want us doing.
Stage 4: Setting the pavers (days 3 to 4)
We lay the pattern you picked, cutting edges clean with a saw rather than snapping bricks and hoping. On a two-car drive with a straightforward running-bond pattern, setting takes a day and a half to two days. Herringbone and curved layouts take longer, and that’s reflected upfront in the quote, not sprung on you at the end.
Stage 5: Compaction, sand, and cleanup (day 5)
We compact the field, sweep polymeric sand into the joints, wet it down, and check the whole surface for rockers and lips. You get a walkthrough at the end, and we’re not shy about fixing anything you spot.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Paver Options You’ll Actually Choose Between
Before the first shovel moves, you’re picking a material, a pattern, and a finish. Here’s what the choices mean in real terms.
- Concrete pavers vs. clay brick. Concrete pavers are the workhorse, the price anchor of that $7,000 to $18,000 range, and hold color well in San Dimas heat. Clay brick pavers cost more per square foot but earn it back in decades of wear and a warmer look that suits the older homes near downtown.
- Permeable systems. On foothill slopes, a permeable paver system with an open-graded base lets winter rain drain through instead of sheeting toward the garage. It costs more upfront; it can save a drainage retrofit.
- Pattern. Running bond reads clean and modern and installs fastest, which keeps labor down. Herringbone handles tire loads better and looks richer; it costs more in cutting and time.
- Color and finish. Tumbled edges read like age and hide tire marks; sharp-edged pavers look crisp and show every bit of dirt. Sealed finishes deepen color but need refreshing; unsealed pavers blend naturally with San Dimas’s rural street character.
- Thickness grade. Standard 2⅜-inch pavers are made for driveways. Thinner wall pavers aren’t, no matter what a sale price suggests.
We quote Belgian-style concrete pavers from Belgard and comparable lines because the color and finishing match high-end San Dimas homes without the import-tile premiums. Brand availability shifts, so we’ll show you current samples.
What Paver Driveways Cost in San Dimas, CA

Expect $7,000 to $18,000 for a paver driveway installation in San Dimas, with most two-car drives landing between $9,000 and $13,000. That’s our whole range, and here’s what pushes a job to either end.
- Size and shape. Square footage drives material cost first. Curves, corners, and a third parking pad add cutting and layout time.
- Existing surface and removal. Tearing out thick old concrete plus haul-off adds to the front of the job; pulling tired pavers is lighter work.
- Grading and slope. Foothill approaches and retaining-wall tie-ins mean more excavation, a deeper base, and sometimes drainage work. This is the single biggest variable in San Dimas.
- Paver grade and pattern. Clay brick and herringbone sit at the high end; standard concrete pavers in running bond at the low end.
- Permits and inspection. A driveway that changes the approach, drainage, or slope may trigger a grading review. We pull it and don’t hide the cost.
Your written estimate is a line-item quote: demo, base, restraint, pavers, sand, and cleanup broken out. What’s often not included, unless you ask: driveway sealing down the road, landscape repair, and moving an irrigation line that crosses the footprint. We’ll flag those before we start, and the number you see is the number you pay. Every project comes with our 730-Day Done Right Promise, and $1,000 off applies to projects over $10,000.
See the difference
Before
After
Before
After
Before
AfterWhat San Dimas Homes Specifically Do to This Job
San Dimas sits where the San Gabriel Valley runs into the foothills, on an alluvial fan below the mountains, and that shapes the work. On the flatter lots off the valley floor, a paver driveway is a straightforward base-and-lay job. Head up into the foothill streets above downtown, though, and you’re grading a slope, tying into a retaining wall, and engineering drainage because those decomposed granite slopes saturate in winter storms. We grade those approaches to shed water toward the street, not the foundation.
Older mid-century and 1960s-80s homes across San Dimas, with stucco walls and original foundations, often have approaches that have settled or drained toward the garage for years. That’s a fix we make as part of the drive, not a surprise later. Changes to an approach’s slope or drainage can trigger the city’s grading review, so we handle permitting and inspection. Neighbors in the hillside areas also deal with HOA materials rules, and we’ll work within them. If the driveway is part of a full Driveway & Pavers in San Dimas plan that includes patios or walkways, we’ll scope it together. And if the front entry feels dated next to a new drive, homeowners often pair this with Door Installation in San Dimas, or with Cabinets & Countertops in San Dimas if the project stretches into the house. You can see our broader work on Driveway & Pavers if you want the full picture.
Serving San Dimas, CA – Our Local Coverage Area
We serve San Dimas and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Paver Driveways in San Dimas

A typical two-car paver driveway takes 4 to 6 working days, weather permitting. Graded or hillside sites can run an extra day or two for base prep and drainage. We give you the schedule in writing with the estimate, so you know when the driveway’s back in service.
It depends on whether your project changes the approach, slope, or drainage. A straightforward resurfacing over an existing footprint usually doesn’t; a new approach, a grade change, or a retaining-wall tie-in often triggers the city’s grading review. We confirm what’s needed and pull the permit for you.
Yes, and it’s the right time to handle it. If the base under your old drive has settled or your lot is draining toward the garage, we re-grade it before laying pavers, so the new drive doesn’t inherit the old problem. That’s part of why base prep gets its own stage on every job.
Most San Dimas homeowners spend between $9,000 and $13,000 for a two-car driveway, within our $7,000 to $18,000 range. Slope, paver grade, pattern, and whether old concrete comes out are the main variables. Call (844) 662-2335 for an exact quote. Estimates are free.
Every paver driveway we install is backed by our 730-Day Done Right Promise. If something isn’t right within that window, we make it right. You get the terms in writing when you sign, not buried in fine print. Our technicians have up to 12 years of experience, and the estimate spells it all out.
Get a Free San Dimas Paver Driveway Estimate
If you’re weighing paver driveways in San Dimas, start with a free on-site estimate. We’ll measure the footprint, check the slope and drainage, and hand you a written line-item quote, plus a sample of the paver lines that fit your home. Call (844) 662-2335. A live person answers, 24 hours a day, and we’ll book a visit that works around your schedule.
Written by the team at Groundwork Construction Co.












